8,732
edits
Changes
→A Sample Application
The parameters are shown on the left side of the COMMUNICATIONSETUP display, and the available options for each parameter are listedin the center. The default parameters appear on the right-hand side ofthe display, with the cursor (a flashing square) on the first entry.Notice that all the default values except RS-232 PORT and AUTO LOGONagree with the values required to communicate with XYZ. PressENTER three times to accept the first three values. The cursor nowappears to the right of RS-232 PORT. Press 2 to select port #2, and thenpress ENTER twice to move the cursor to LOGON.
Notice that all the default values except RS-232 PORT and AUTO LOGON agree with the values required to communicate with XYZ. Press '''ENTER''' three times to accept the first three values. The cursor now appears to the right of RS-232 PORT. Press '''2''' to select port #'''2''', and then press '''ENTER''' twice to move the cursor to LOGON. If you make a mistake, move the cursor back up to the entry by pressing '''FCTN''' [[File:Up-Arrow.png|30px25px]] (UP). Retype the desired selection, and then press '''ENTER ''' repeatedly to move the cursor down to LOGON.
At this point, if you were using the module's automatic log-on feature, you would insert the appropriate diskette into Disk Drive One and enter the file name of your log-on program. For this demonstration, however, we are not using the auto-log-on feature. Therefore, simply press '''ENTER''' to accept the default value LOGON.
